Quick Answer: How To Replace Harley Davidson Hand Grips?

What size are stock Harley grips?

Grips come in two standard sizes to choose from, either 1″ or 7/8″. So when you’re looking to replace you grips, measure your handlebar diameter and match the grips to the size needed. As a general rule, 7/8″ diameter grips typically accompany street/metric bikes, while 1″ typically fit Harley/Cruiser applications.

Does Hairspray work as Grip glue?

While many bikers use glue to keep their grips on tight, some have found at home remedies to work just as well. Some bikers swear by using hairspray as an adhesive. Simply spray a thin layer of aerosol hairspray onto your handlebars, and fashion the grips over the spray.

Can you use super glue for motorcycle grips?

You can use this clear super glue on metal, rubber, and fiberglass. This makes it compatible with your new rubber motorcycle grips and metal handlebars. This glue is waterproof, so once you apply it, whatever you glued isn’t moving—ever.

How do you remove metal motorcycle grips?

To remove the grips, simply take a razor blade and make a cut down the length of the grip. Be sure to avoid where any wires may be under the grip, and try not to scratch or cut into the surface beneath if you have chrome handle bars. Once you’ve cut the grip, peel it off of the handlebar.

You might be interested:  Often asked: When To Replace The Harley Davidson Primary Automatic Chain Tensioner Replacement?

How do you remove glued grips?

I use a thin screwdriver or spoke and a spraybottle with soapy water. Pry, spray, work it around it a bit and it usually twists right off. In the past I’ve used WD-40, but I did wash the grips in hot soapy water before putting them back on along with cleaning the handlebar with alcohol followed by soapy water.

Leave a Reply

Your email address will not be published. Required fields are marked *