FAQ: How Do I Figure Out A Harley-davidson Speedometer Ratio?

What is a 2 1 speedometer?

“How to choose the right Speedometer Ratio” 1:1 Ratio Fits 4-speed 1962-80 FL 2:1 Ratio Fits 1947-61 FL

What is ratio of speedometer?

The ratio shows the relationship between the speedometer input (cable rotation speed) and the speedometer output (reading), which takes into account such factors as the size of the front wheel & tire if the speedo is wheel driven, or the tail shaft gear ratios, final drive ratio, and the rear tire diameter on

How do you calibrate a Harley Davidson speedometer?

Press and hold the UP or DOWN button while you are driving to change the speedometer reading until the speedometer is correct. The bike must be moving in order to adjust the speedometer. 3. After the SIM-1 has detected that no buttons have been pressed for about 10 seconds, the new calibration is stored.

How fast are we going?

Thus, the surface of the earth at the equator moves at a speed of 460 meters per second–or roughly 1,000 miles per hour. As schoolchildren, we learn that the earth is moving about our sun in a very nearly circular orbit. It covers this route at a speed of nearly 30 kilometers per second, or 67,000 miles per hour.

You might be interested:  Readers ask: What Is The Biggest Motor Harley Davidson Makes?

What do numbers symbolize on the speedometer?

it shows is the distance your bike has covered. If the right number is in a white dial, it means that it shows the meters in 100s covered. So, if it shows 22595 with 5 being in the white dial, that means the distance covered is 2259 km and 500 m.

How do you calibrate a mechanical speedometer?

Press and hold the calibration button located on the speedometer, start the vehicle, and then release the button. Press that button again and then take the test drive. Once you have driven the distance needed, press the button once more and the speedometer will calibrate itself to accommodate the new tire size.

How do you get moisture out of a Harley speedometer?

If the problem persists after a long ride, you may need to heat the instruments to dry them out. Instead of using a hair dryer, put a light globe close to where the moisture is and leave it on over night or for a couple of days, depending on how bad the condensation is.

How do you fix condensation on a speedometer?

Some say take a hair dryer on low and gently warm the bezel glass until the water evaporates. Or wait it out. It should go away eventually.

Leave a Reply

Your email address will not be published. Required fields are marked *